SPECIFICATIONS
TDS Water Quality Tester – Meter Hold 3

Measurement Range: 1-999 PPM.
Operating Temperature: 0 – 80°C, can be stored at -30°C.
Large LCD Display: Waterproof LCD design for easy reading.
Power Source: Uses CR1620 1.5V batteries (2 pieces), lasting over 3 years. Automatically shuts off after 10 minutes of inactivity to save battery.
Design Feature: Electrode cap doubles as a container for testing solutions.
Fast Measurement: Ultra-sensitive sensor provides accurate readings within 5 seconds.
Accuracy: ±2% margin of error.
Automatic Temperature Compensation (ATC).
Clear LCD Screen: Provides clear and easy-to-read measurements.
HOW TO USE

Take the TDS water tester out of its protective case and remove the cap from the tip of the tester.
Turn on the device by pressing the ON/OFF button once before dipping it into the water. The tester will display "000."
Dip the tester’s tip into the water to be tested, ensuring not to submerge it too deeply—approximately 2 inches (~5 cm) is sufficient.
Wait for the reading to stabilize. The tester will automatically adjust for temperature changes. After 10-30 seconds, the device will show a stable reading. Remove the tester from the water and press the HOLD button to lock the displayed value.
Turn off the device by pressing the ON/OFF button again. If not manually turned off, the tester will automatically power off after 10 minutes of inactivity.
Dry the tester after use by gently shaking it to remove any remaining water from the tip, then wipe it clean with a dry cloth.
Note: If the tester displays "X10," it means the reading is multiplied by 10.

OUTSTANDING ADVANTAGES

Please Fill Out Order Form Below

QUALITY

The item are 100% new, we offer the best products at the best price

buy now